Ê×Ò³ ÖÐÎÄ°æ English
Workflow 1
First you should put the bulk waste gathered in the transfer station into the compressor, and then the bench on the compressor presses it into a solid clump driven by the hydraulic pressure. The waste water squeezed flows into the colleting well through the compressor and is pumped into the drain by non-block auto-sewage pump. Then lift up the pressed waste from the compressor, push it into truck container or storage car and wait for the truck to carry it away. In this way, a recycling process of compressing-pushing is completed.

Workflow 2
Dump the bulk waste into waste-treatment box. Start hydraulic system after it has been placed at upper surface of the box; the bench then presses the loose waste into a solid clump under the pushing force of the oil cylinder. Repeat it for three or four times. ?Lift the bench when the first box gets filled, and next start box-displacing to move forward the first box, the second box is then right below the bench, and the second pressing process is conducted in the same way. Next load the two pressed waste. Lift the boxes to the same level as the truck carriage. Start to push the waste into the carriage. In this way, another recycling-pushing process is completed.
Workflow 3
Dump the garbage collected by the garbage truck into the dumper, start tipping devices and then dump the waste from the dumper into compressing barn. Start compressing after it is filled up. Then lock the equipment with the bolt and push the waste into roll-off container. Repeat the above process for several times until the container is filled up. Move the compressor head between the two roll-off containers if necessary and compress the waste by turns to enhance efficiency.